This article has been created to guide you through the procedure for calibrating your cPad.
This is particularly useful when the touch screen is a long way out of calibration, meaning you can’t enter the configuration menus via the Z pattern.
If you don't already have Putty you can download it here.
Step 1: Type in the IP address of your cPad as shown and click Open
To obtain username and password contact support.
Step 2: Type the following commands to run...
# source /etc/qt4-env “ press Enter” (note: there is space in between source & / )
# ts_calibrate “press Enter”
Once these two commands have been sent, you can perform the calibration on the cPad, as shown below:
Step 3: Touch screen crosshair to calibrate
Step 4: Exit Putty and reboot the cpad.
If following the above steps does not solve the issue for you. Please contact us via our email firstname.lastname@example.org.